cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
5853
Views
0
Helpful
2
Replies

Ctrl + Break sequence not working

stevec90
Level 1
Level 1

I can not get the switch into rommon mode with the Ctrl + Break sequence, any suggestions? It's a 3512 switch. I just reset the password on another 3512 with no problem. ??

1 Accepted Solution

Accepted Solutions

Ganesh Hariharan
VIP Alumni
VIP Alumni

I can not get the switch into rommon mode with the Ctrl + Break sequence, any suggestions? It's a 3512 switch. I just reset the password on another 3512 with no problem. ??

Hi,

Check out the below link for password recovery on cisco switches series

http://www-tss.cisco.com/eservice/compass/common/activities/password_cat_2950.htm

HTH

Ganesh.H

View solution in original post

2 Replies 2

Ganesh Hariharan
VIP Alumni
VIP Alumni

I can not get the switch into rommon mode with the Ctrl + Break sequence, any suggestions? It's a 3512 switch. I just reset the password on another 3512 with no problem. ??

Hi,

Check out the below link for password recovery on cisco switches series

http://www-tss.cisco.com/eservice/compass/common/activities/password_cat_2950.htm

HTH

Ganesh.H

Thanks, that did the trick. I guess the break key sequence was disabled on this switch? Something I'll have to look into -- I know the key sequence can be disabled on a router.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: