SNMPv2-SMI::enterprises.9.9.13.1.5.1.2.1 = STRING: "Power Supply 1"

SNMPv2-SMI::enterprises.9.9.13.1.5.1.2.2 = STRING: "Power Supply 2"

SNMPv2-SMI::enterprises.9.9.13.1.5.1.3.1 = INTEGER: 1

SNMPv2-SMI::enterprises.9.9.13.1.5.1.3.2 = INTEGER: 6

SNMPv2-SMI::enterprises.9.9.13.1.5.1.4.1 = INTEGER: 2

SNMPv2-SMI::enterprises.9.9.13.1.5.1.4.2 = INTEGER: 2

It does appear DFM should have detected this.  Power Supply 2 is clearly not functioning.  Does the DFM Detailed Device View show PS2 as being found and managed?

Yes, the device is known in DFM (I did a re-import just in case)

Device Status             = Known
Device Type               = Switches and Hubs
Aliases                       = N/A
Containments              = N/A
DFM Processing          = Active
Time Last Discovered = 01-Feb-2010 12:28:43
Import Time Stamp       = 01-Feb-2010 12:19:56

    *** Data Collector Status Information ***
Error Code                   = N/A
Error Message             = N/A

The power supply condition isn't reflected in the alerts.

Could it be that if the power supply is off to begin with when it does it's discovery, it doesn't register an alarm?

What does the Detailed Device View show for this switch?  DFM may be ignoring it since its state is not functioning, and not "critical."

Hello,

I have the same problem. I attach some files.

what can be the problem?

Thanks

Start a new thread for your issue.

Hello, you can see my answer about this problem, i have a case open, the cisco TAC think the avaibility of the patch is September.

Regards

Nicolas

Hello

We have the same problem, no trap is coming into the LMS when we turn off a power supply of a 4500. What's the status on that? any solution?

Thank you