CISCO AIR-LAP1252AG-A-K9 Autonomous DHCP config?

Unanswered Question
Jan 29th, 2010

N00b questions:

  1. Can the 1252AG provide server DHCP in the Autonomous IOS configuration ? ( The WAP is connected to a Linksys router that is providing a NAT address via DHCP to the ethernet interface)
  2. What is the most basic DHCP configuration option ?
  3. I'm assuming the WAP can also pass through the NAT / DHCP from the Linksys router ? What would be the most basic configuration for that?



I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
nickml007 Fri, 01/29/2010 - 08:48

"Configuring the Access Point to Provide DHCP Service

These sections describe how to configure the access point to act as a DHCP server:

•Setting up the DHCP Server

•Monitoring and Maintaining the DHCP Server Access Point
Setting up the DHCP Server

By default, access points are configured to receive IP settings from a DHCP server on your network. You can also configure an access point to act as a DHCP server to assign IP settings to devices on both your wired and wireless LANs."

I'm assuming this also applies to the 1252?


This Discussion

Related Content