SPA525G on UC520

Unanswered Question
Jan 29th, 2010

How can I configure my SPA525G to use the buttons on the right side of the display to show the status of BRI0/1/0 and BRI0/1/1 as follows:
unlit: not in use

green: in use from this phone

red: in use from another phone

green blinking: on hold, pick up by pressing button

red blinking: on hold, cannot pick up

And, when I place a call on hold:

single press on hold button: green blinking on all phones

double press on hold button: green blinking on my phone, red blinking on all other phones

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Steven Smith Fri, 01/29/2010 - 10:06

I don't believe we can do that today.  The functionality is similar to a key system, but we only support that on FXO ports.

eljakimit Fri, 01/29/2010 - 10:38

When do you expect this to be possible?

Is there a way to get functionality that resembles this behaviour?

Steven Smith Fri, 01/29/2010 - 10:48

I wouldn't expect this any time soon.  I don't know if this is on the road map, but I don't think that this is.

Do your calls always come in to the same phone number?  What you could do is setup a CFB on the first number so that the second call that comes in get a different extension.  Then, have these to extensions on the phones that want this ability.

eljakimit Mon, 02/01/2010 - 00:32

Yes, all calls come in on the same number.

Can you give me a hint regarding where in the CCA I would set this up?

Thanks!

Eljakim

Steven Smith Mon, 02/01/2010 - 09:16

Sure.

On the phones that you want to have this, have ext 111 as a shared DN to those phones.  Have ext 112 as well, and so on.  Have 111 call forward busy to 112.  This would be done under the users telephony -> voice -> users.

I think that would to what you are looking for.

Actions

This Discussion

Related Content