SLM2008 firmware upgrade 2.0.0.10

Unanswered Question
Jan 29th, 2010

I have upgrade to 2.0.0.10 with the upgrade reported as successful. Since the upgrade I have not been able to access the web interface. I have cleared the browser cache, tried alternate browsers and different hosts as well as restarting and reset the switch.

A typical connection request lasts about 15/20 seconds with browser status reported "Done" and a blank page presented

Short of performing a factory reset are there any suggestions?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
David Hornstein Sat, 02/06/2010 - 14:24

Hi feeks,

I guess you have the problem resolved by now.

But the release notes mentions a few things regarding what you may notice after the upgrade, click on the link below;

release notes

regards Dave

Actions

This Discussion