I have some problem in cisco 3400ME switch.
There is only 4 ports allowed "port-type NNI" and then when i config more than four ports to NNI i got Error msg
"Command Rejected : Exceeded NNI ports Allowed"
We are using c3400ME-12.2(44)SE.bin IOS
currently int fastethernet port 1 & 2 and GigabiteEther 1 & 2 are port-type NNI , when i give port 3 or any ports i got abeve mention error msg.
when i remove any one port from nni to uni and then config to any other port to NNI then we are able to config to NNI port.
So that means there are only 4 ports allowed to config on interface port-type NNI.
Which IOS upgrade to config all ports to NNI.
I need to config all ports are "switchport protected" and spanning-tree also on interface ( it is possible when all ports are in NNI tyne).
Pl help me.
Thanks in ADV,
You can upgrade you device to 122-25.SEG3 (metro IP image)
and yes, it will support mere then 4 ports for NNI
|METRO IP ACCESS|
|Release Date: 30/Jul/2007|
|Size: 7575.81 KB (7757626 bytes)|
|Minimum Memory: DRAM:128 MB Flash:32 MB|