CiscoWorks ---Detailed Device View Issue

durgeshk · ‎01-31-2010

Hi, I am facing a issue in DDV, I am getting a lot of alerts because admin status is showing "not present" for an interface but the interface is ok on router 3745. Due to this I am getting frequent alerts once for Admin status up and once for admin status notpresent

Please help me....

Joe Clarke · ‎02-01-2010

Post a walk of the ifTable for this device as well as the specific details of one of these bogus events.

durgeshk · ‎02-02-2010

Thanks Joe to hear from you....

Please guide me how do I make ifTable walk, after that I will send you all the details.

Regards

Durgesh

Joe Clarke · ‎02-02-2010

You can use the SNMP Walk tool in Device Center to do this. Just specify a starting OID of "ifTable".

durgeshk · ‎02-02-2010

Hi Joe,

I tried doing the same and I also specified the OID. But it gives me the attached result.

Please help

Joe Clarke · ‎02-03-2010

You need to specify a starting OID value of "ifTable" (without quotes). If you want, the OID to use is .1.3.6.1.2.1.2.2.

durgeshk · ‎02-03-2010

Hi Joe,

Yes I tried the same using the OID but the result was same as I attached.

Please confirm me, does a normal computer support snmpwalk command or we need to install any special tool or software to run the snmpwalk command from the CLI of computer.

Joe Clarke · ‎02-04-2010

Post a screenshot of the settings you filled out in the SNMP Walk tool.