acs appliance with flapping ethernet interface

Unanswered Question
Feb 1st, 2010
User Badges:

Hello,


we have an acs appliance with software 4.0. Since a couple of weeks the ethernet interface of the appliance starts to flap every minute. Neither changing the switchport nor the cable or the switch was not succesful.


Does anybody know a bug ?


Best regards

Torsten Waibel

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Ganesh Hariharan Mon, 02/01/2010 - 23:22
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016

Hello,


we have an acs appliance with software 4.0. Since a couple of weeks the ethernet interface of the appliance starts to flap every minute. Neither changing the switchport nor the cable or the switch was not succesful.


Does anybody know a bug ?


Best regards

Torsten Waibel


Hi Torsten,


Just try to configure a command via console toggle nic in ACS appliance and then check it happen or not.


HTH


If helpful do rate


Ganesh.H

t.waibel Wed, 02/03/2010 - 04:18
User Badges:

Hi Ganesh,


sorry the command is not known by the windows acs appliance.


acs2>  toggle nic
toggle nic: command not found.


Our hardware suppliers doesn't found any bug together with cisco.

Finally we will change the hardware.


Best regards

Torsten

Actions

This Discussion