LMS Port-Security on a Catalyst switch WS-C2960-48TT-S

Unanswered Question
Feb 1st, 2010


I cannot configure port-security from the ChasisView component of LMS,

on a WS-C2960-48TT-S switch. When I select "Port Security..." from the

"Category" combobox, I get this error message:

Can not Configure Port Security Because Dynamic Port

I have updated ChasisView with the latest .zip file from here


but I'm still getting this error message.

The configuration of the interface, on which I'm trying to set port security this is below

(so there are no dynamic settings):

interface FastEthernet0/9
switchport access vlan XXX
switchport mode access

Thanks for any hints/help!



Version & Patch  Level: 6.1.9

Active Device Package: Catalyst 2960 Device  Package(6.0)


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Joe Clarke Mon, 02/01/2010 - 07:30

This is most likely a device problem.  A similar bug was opened for 6500s (                                                                                                          CSCsv63323), but it was closed since the problem was due to buggy IOS code.  What version of code is the 2960 running?

silviugolo Mon, 02/01/2010 - 07:44

Hi Joe,

It's Version 12.2(46)SE.


System image file is "flash:/c2960-lanlite-mz.122-46.SE/c2960-lanlite-mz.122-46.SE.bin"


This Discussion

Related Content