show interface command

Answered Question
Feb 1st, 2010

I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average.  The is a command to modify this for a particular, shorter time frame.  I can't recall what the command is but I know it's there since one of my service providers had me enter it at one time.  Anyone know what this command is?

Eric

I have this problem too.
0 votes
Correct Answer by Jon Marshall about 6 years 10 months ago

netspec01a wrote:

I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average.  The is a command to modify this for a particular, shorter time frame.  I can't recall what the command is but I know it's there since one of my service providers had me enter it at one time.  Anyone know what this command is?

Eric

Eric

load-interval 30 - 600 (seconds)

Jon

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Jon Marshall Mon, 02/01/2010 - 13:26

netspec01a wrote:

I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average.  The is a command to modify this for a particular, shorter time frame.  I can't recall what the command is but I know it's there since one of my service providers had me enter it at one time.  Anyone know what this command is?

Eric

Eric

load-interval 30 - 600 (seconds)

Jon

Actions

This Discussion