02-01-2010 01:23 PM - edited 03-04-2019 07:22 AM
I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average. The is a command to modify this for a particular, shorter time frame. I can't recall what the command is but I know it's there since one of my service providers had me enter it at one time. Anyone know what this command is?
Eric
Solved! Go to Solution.
02-01-2010 01:26 PM
netspec01a wrote:
I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average. The is a command to modify this for a particular, shorter time frame. I can't recall what the command is but I know it's there since one of my service providers had me enter it at one time. Anyone know what this command is?
Eric
Eric
load-interval 30 - 600 (seconds)
Jon
02-01-2010 01:26 PM
netspec01a wrote:
I believe that the "show interface" commad normally shows interface utilization based on a 5-minute average. The is a command to modify this for a particular, shorter time frame. I can't recall what the command is but I know it's there since one of my service providers had me enter it at one time. Anyone know what this command is?
Eric
Eric
load-interval 30 - 600 (seconds)
Jon
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide