ACS authentication using AD

Answered Question
Feb 2nd, 2010
User Badges:

we are trying to set up Cisco Secure ACS (5.0) which will automatically allocate unknown users to a Guest Vlan.  802.1X is configured on the switches but our lack of undersatnding of the ACS prevents us completing this task.  I am aware that we need to configure radius even though we want Microsoft AD to do the authentication but we do not know the correct procedure - any assistance would be appreciated

Correct Answer by Ganesh Hariharan about 7 years 1 month ago


we are trying to
set up Cisco Secure ACS (5.0) which will automatically allocate unknown
users to a Guest Vlan.  802.1X is configured on the switches but our
lack of undersatnding of the ACS prevents us completing this task.  I
am aware that we need to configure radius even though we want Microsoft
AD to do the authentication but we do not know the correct procedure -
any assistance would be appreciated


Hi,


Check out the below link on 802.1x configurtaion in switches along with ACS configuration,hope that help !!


http://www.cisco.com/en/US/tech/tk389/tk814/technologies_configuration_example09186a00808abf2d.shtml  -- 802.1x switch and ACS configuration


http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193aa0.html


If helpful do rate the post


Ganesh.H

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Ganesh Hariharan Tue, 02/02/2010 - 02:01
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Member's Choice, February 2016


we are trying to
set up Cisco Secure ACS (5.0) which will automatically allocate unknown
users to a Guest Vlan.  802.1X is configured on the switches but our
lack of undersatnding of the ACS prevents us completing this task.  I
am aware that we need to configure radius even though we want Microsoft
AD to do the authentication but we do not know the correct procedure -
any assistance would be appreciated


Hi,


Check out the below link on 802.1x configurtaion in switches along with ACS configuration,hope that help !!


http://www.cisco.com/en/US/tech/tk389/tk814/technologies_configuration_example09186a00808abf2d.shtml  -- 802.1x switch and ACS configuration


http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193aa0.html


If helpful do rate the post


Ganesh.H

Actions

This Discussion