cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
742
Views
0
Helpful
1
Replies

ACS authentication using AD

KeithN123
Level 1
Level 1

we are trying to set up Cisco Secure ACS (5.0) which will automatically allocate unknown users to a Guest Vlan.  802.1X is configured on the switches but our lack of undersatnding of the ACS prevents us completing this task.  I am aware that we need to configure radius even though we want Microsoft AD to do the authentication but we do not know the correct procedure - any assistance would be appreciated

1 Accepted Solution

Accepted Solutions

Ganesh Hariharan
VIP Alumni
VIP Alumni

we are trying to
set up Cisco Secure ACS (5.0) which will automatically allocate unknown
users to a Guest Vlan.  802.1X is configured on the switches but our
lack of undersatnding of the ACS prevents us completing this task.  I
am aware that we need to configure radius even though we want Microsoft
AD to do the authentication but we do not know the correct procedure -
any assistance would be appreciated

Hi,

Check out the below link on 802.1x configurtaion in switches along with ACS configuration,hope that help !!

http://www.cisco.com/en/US/tech/tk389/tk814/technologies_configuration_example09186a00808abf2d.shtml  -- 802.1x switch and ACS configuration

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193aa0.html

If helpful do rate the post

Ganesh.H

View solution in original post

1 Reply 1

Ganesh Hariharan
VIP Alumni
VIP Alumni

we are trying to
set up Cisco Secure ACS (5.0) which will automatically allocate unknown
users to a Guest Vlan.  802.1X is configured on the switches but our
lack of undersatnding of the ACS prevents us completing this task.  I
am aware that we need to configure radius even though we want Microsoft
AD to do the authentication but we do not know the correct procedure -
any assistance would be appreciated

Hi,

Check out the below link on 802.1x configurtaion in switches along with ACS configuration,hope that help !!

http://www.cisco.com/en/US/tech/tk389/tk814/technologies_configuration_example09186a00808abf2d.shtml  -- 802.1x switch and ACS configuration

http://www.cisco.com/en/US/products/sw/secursw/ps5338/products_installation_and_configuration_guide_chapter09186a0080193aa0.html

If helpful do rate the post

Ganesh.H

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: