Cisco Call Manage Express Speakerphone disabled

Unanswered Question
paolo bevilacqua Wed, 02/03/2010 - 03:47
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Why do yuo say it is disabled ?

paolo bevilacqua Wed, 02/03/2010 - 06:29
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

Try resetting the phone via the keypad sequence at boot.

Rob Huffman Wed, 02/03/2010 - 06:30
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hi Michael,


Just to add another thought to the good tips from my friend Paolo,

here are the commands to enable/disable the speakerphone;


This can be done on CME on a phone by phone basis. Have a look;




service phone




To modify the vendorConfig parameters in the configuration file, use the service phone command in telephony-service or ephone-template configuration mode. To disable a setting, use the no form of this command.




service phone parameter-name parameter-value




no service phone parameter-name parameter-value










This command in telephony-service configuration mode modifies vendorConfig parameters in the configuration file for phones in a Cisco Unified CME system.




In Cisco Unified CME 4.0 and later versions, support for creating configuration files at a per-phone level was supported and this command in ephone-template configuration mode creates an ephone-template of vendorConfig parameters which can then be applied to an individual Cisco Unified IP phone in Cisco Unified CME.




disableSpeaker {true | false}




Enables and disables the speakerphone.




true Enabled (default).




false Disabled.






Router(config)# telephony-service




Router(config-telephony)# service phone disableSpeaker false














The following example shows how to disable the Speakerphone on an individual IP phone (ephone 15) using an ephone template:




Router(config)# ephone-template 8




Router(config-ephone-template)# service phone disableSpeaker True (**this would need to be FALSE)




Router(config-ephone-template)# exit




Router(config)# ephone 15




Router(config-ephone)# ephone-template 8




Router(config-ephone)# exit




Router(config)# telephony-service




Router(config-telephony)# create cnf-files




Router(config-telephony)# exit




Router(config)# ephone 15




Router(config-ephone)# reset




Hope this helps!


Rob

Actions

This Discussion