SRW2024 - HOSTG_rscode_file_load: could not load file

Unanswered Question
Feb 2nd, 2010
User Badges:

Hello


I'm able to connect to the switch via HyperTerminal. I see that the switch is always rebooting because it can't load the boot file:


-> HOSTG_rscode_file_load: could not load file


I have check in the internet for a solution and I could find different notes about the  runtop_boot-101.rfb file for a SRW2024 switch. But I couldn't find a link where to get the file.


Please could you help me? Thank you very much.


Regards,

Angelo


=======================================================

As additional information here also the output of the console:


...

BOOT Software Version 1.0.0.03 Built  08-Jun-2004  09:48:10


CPU - FireFox 88E6218 ARM946E-S processor
64 MByte SDRAM. I-Cache 8 KB. D-Cache 8 KB. Cache Enabled.


Autoboot in 2 seconds - press RETURN or Esc. to abort and enter prom.
Preparing to decompress...


Decompressing SW from flash
HOSTG_rscode_file_load: could not load file


Perform WARM BOOT ...

...

=======================================================

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
angelo1969 Wed, 02/03/2010 - 15:02
User Badges:

I have found the solution:


Import the file "srw2016-24-10086.ros" (stored as SRW2024_V1_0_Firmware.zip on www.cisco.com/support) using HyperTermin and Xmodem:


- Configure HyperTerminal -> set baud rate to 38400

- Switch on the switch

- During the POST press immediatly the key

- Choose [1] Download Software and click with teh right mouse button anywhere on the HyperTerminal window

- select "Send File"

- Browse to the file "srw2016-24-10086.ros"

- Define the protocol Xmodem


Wait about 25 minutes to finish the transfer... After the problem should be resolve!


Caution: If you import the file "ls20xx-12230.ros" the problem happens again. That what happens on my switch (?)

David Hornstein Sat, 02/06/2010 - 14:19
User Badges:
  • Gold, 750 points or more

Hi Angelo,


By the looks of your explaination you basically seem to have reloaded a software version back onto the unit.

Thank you very much for letting us all know the result.  We all learn from this community.


regards Dave

Actions

This Discussion