Input gain for SPA504g

Unanswered Question

I am trying to figure out how to set my input gain for my SPA504g phones.  I was able to view the phone's website and can see the settings listed there, but can't seem to get into an admin mode.  using the http://phoneip/admin just shows the same page as the http://phoneip site.  Do I need to somehow enable the admin mode to make these changes or can I change these settings on the phone itself?

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Cory Andrews Tue, 03/16/2010 - 09:23

John, are you using your Cisco SPA504G

with a VoIP service provider, or with your own IP PBX?

ericdolton Fri, 05/07/2010 - 10:37

Any progress on this?  I am having the same issue trying to make changes

via the web interface

No luck yet.  Someone mentioned that you have to enable the admin settings on the default XML file for the phone.  I am the admin for our phones and UC560 system but have not figured out how to do that.  If I knew how I have the credentials to do it, just not the knowledge!  (I know, that can be a dangerous position to be in.)

bagattij81 Wed, 07/06/2011 - 12:06

im on the phone with the SBSC about this very issue, i think its rather ridiculous that this Cisco has not replied to this question.

Actions

This Discussion