Solved: RME compliance issue - Check for presence of cmd "OR" cmd

charlie-hall · ‎02-02-2010

It does not appear to me that I can do "OR" logic when checking commands on an interface, for example this is what I want to accomplish:

IF switchport mode access

then IF this command exist "dot1x port-control" OR this command exit "switchport port-security"

do nothing,

Else

Display the Interface Name

I best I have been able to do, is to check for the presense of both commands and a success will display one command per interface in the report and displaying both commands per interface means a failure.

I am running RME 4.1.1

Joe Clarke · ‎02-02-2010

You should be able to do something like this to assert the command exists:

+ [#(dot1x port-control|switchport port-security).*#]

View solution in original post

Joe Clarke · ‎02-02-2010

You should be able to do something like this to assert the command exists:

+ [#(dot1x port-control|switchport port-security).*#]

charlie-hall · ‎02-03-2010

I keep thinking of the "|" pipe in IOS.

That was it though.

I used "!Vlan", so we will check all interfaces except Vlan Interfaces.

I am able to run this on all switches in a subnet, and it works great.

Name:

Name: CheckForDot1X SubMode: No isPrerequisite: No
Ordered : No Prerequisite-Commandset : AccessPortCmdSet Parent: AccessPortCmdSet
+ [#(dot1x port-control|switchport port-security).*#]

AccessPortCmdSet SubMode: Yes isPrerequisite: Yes
Ordered : No Prerequisite-Commandset : none Parent: none
interface [#!Vlan.*#]
+ switchport mode access

thanks!