cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1370
Views
0
Helpful
1
Replies

CME change extension length

Elliott Roberts
Level 1
Level 1

On the initial setup I chose 4 digits as the extension length.

Need to change that to 6 however there doesnt seem to be anyway to do this without re running the setup wizard.

When I try to re-run the wizard it refuses indicating the system is not qualified.

When I try to do no telepony-service from CLI it indicates there is an active call

DN 9 has active call on interface 50/0/9 CH1

This seems to be an AA or VM hunt group that I am unable to shutdown.

no voice-port 50/0/9 doesnt work it fails at 50

Is there a way to just change the extension length so the CME Gui accepts the new extension lenght or a way to kill 50/0/9 so I can re run the wizard?

Thanks

1 Reply 1

Brandon Buffin
VIP Alumni
VIP Alumni

I don't believe the GUI enforces the extension length? I just tested on a CME system and was able to enter a 7 digit DN although I'm currently setup for 4 digits. You cannot change a DN from the GUI. You would need to delete and readd it. You can, however, change the DN from the CLI.

Hope this helps.

Brandon

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: