eigrp change neighbor metric

Unanswered Question
Feb 4th, 2010
User Badges:

Hello


I have in the LAB hub ans spoke NBMA topology 1 hub and 2 spoke

and i was started EIGRP, HUB was push default route to the spokes.

i need some changes only in the HUB side what will be change neighbor metrik only one neighbor

if i change the interface on the HUB ( delay or bandwith ) this will be affect both spokes

i need change metric only in the one spoke

is it possible with EIGRP  ?

i can't found solution

Thank you

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Jon Marshall Thu, 02/04/2010 - 01:37
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

m.govorov wrote:


Hello


I have in the LAB hub ans spoke NBMA topology 1 hub and 2 spoke

and i was started EIGRP, HUB was push default route to the spokes.

i need some changes only in the HUB side what will be change neighbor metrik only one neighbor

if i change the interface on the HUB ( delay or bandwith ) this will be affect both spokes

i need change metric only in the one spoke

is it possible with EIGRP  ?

i can't found solution

Thank you


Yes, you can use an offset-list which allows you to modify the metric on a per interface level -


http://www.cisco.com/en/US/docs/ios/iproute/command/reference/irp_eig2.html#wp1012264


Jon

m.govorov Thu, 02/04/2010 - 03:05
User Badges:

Hello

but i have configured frame-relay in the physical interface so if i use offset-list it will change to both spoke

because both spokes was conected to one HUB serial interface


Thank you

Jon Marshall Thu, 02/04/2010 - 04:35
User Badges:
  • Super Blue, 32500 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 LAN, WAN

m.govorov wrote:


Hello

but i have configured frame-relay in the physical interface so if i use offset-list it will change to both spoke

because both spokes was conected to one HUB serial interface


Thank you


Ahh, then no you cannot do this. If you need to do this you will need to reconfigure your frame-relay to use subinterfaces and then you can apply the offset-list to the subinterface.


Jon

Actions

This Discussion