02-04-2010 12:04 AM - edited 03-06-2019 09:34 AM
Hello
I have in the LAB hub ans spoke NBMA topology 1 hub and 2 spoke
and i was started EIGRP, HUB was push default route to the spokes.
i need some changes only in the HUB side what will be change neighbor metrik only one neighbor
if i change the interface on the HUB ( delay or bandwith ) this will be affect both spokes
i need change metric only in the one spoke
is it possible with EIGRP ?
i can't found solution
Thank you
02-04-2010 01:37 AM
m.govorov wrote:
Hello
I have in the LAB hub ans spoke NBMA topology 1 hub and 2 spoke
and i was started EIGRP, HUB was push default route to the spokes.
i need some changes only in the HUB side what will be change neighbor metrik only one neighbor
if i change the interface on the HUB ( delay or bandwith ) this will be affect both spokes
i need change metric only in the one spoke
is it possible with EIGRP ?
i can't found solution
Thank you
Yes, you can use an offset-list which allows you to modify the metric on a per interface level -
http://www.cisco.com/en/US/docs/ios/iproute/command/reference/irp_eig2.html#wp1012264
Jon
02-04-2010 03:05 AM
Hello
but i have configured frame-relay in the physical interface so if i use offset-list it will change to both spoke
because both spokes was conected to one HUB serial interface
Thank you
02-04-2010 04:35 AM
m.govorov wrote:
Hello
but i have configured frame-relay in the physical interface so if i use offset-list it will change to both spoke
because both spokes was conected to one HUB serial interface
Thank you
Ahh, then no you cannot do this. If you need to do this you will need to reconfigure your frame-relay to use subinterfaces and then you can apply the offset-list to the subinterface.
Jon
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: