Monitored Lines in CUCM 7.1

Unanswered Question
Feb 4th, 2010
User Badges:
  • Bronze, 100 points or more

Hi All,


I am currently converting an office from CME to use a centralised a CUCM solution.


Some of the users have monitored lines where the lamp lights when the line is busy. I am trying to configure this for CUCM with no luck, I am using a BLF Speed Dial and choosing the line that I want to monitor. The Subscribe CSS on the phone is correct, but after I modify the button Items to display the configured BLF SD it doesn't display on the phone after a reset.


Are there some configuration steps that I am missing?


Thanks in advance

Phil

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (4 ratings)
Loading.
stowellp Tue, 02/09/2010 - 02:04
User Badges:
  • Bronze, 100 points or more

Hi Guys,


Does anyone have any experience in BLF Speed dials that could point me in the right direction?


Cheers,

Phil

stowellp Wed, 02/10/2010 - 06:19
User Badges:
  • Bronze, 100 points or more

Just to let anyone know who is interested that I have solved the problem:


The reason why the BLF SD wasn't appearing/working on the phone was that we use Extension mobility. I didn't have the relevant CSS set up for the end user, I only had it set up on the actual device.


Took me a while to figure that one out!


Phil

Rob Huffman Wed, 02/10/2010 - 07:06
User Badges:
  • Super Red, 40000 points or more
  • Hall of Fame,

    Founding Member

  • Cisco Designated VIP,

    2017 IP Telephony, Unified Communications

Hey Phil,


Thanks for posting up your results here +5 for

this kind gesture that will undoubtedly help others

down the road.


Cheers!

Rob

nikger1980 Thu, 09/15/2016 - 01:39
User Badges:

Old story but always useful info !

Put me out of a lot of waste time today.

Thanks !

Actions

This Discussion