02-04-2010 08:20 AM - edited 03-15-2019 09:18 PM
Hi All,
I am currently converting an office from CME to use a centralised a CUCM solution.
Some of the users have monitored lines where the lamp lights when the line is busy. I am trying to configure this for CUCM with no luck, I am using a BLF Speed Dial and choosing the line that I want to monitor. The Subscribe CSS on the phone is correct, but after I modify the button Items to display the configured BLF SD it doesn't display on the phone after a reset.
Are there some configuration steps that I am missing?
Thanks in advance
Phil
02-09-2010 02:04 AM
Hi Guys,
Does anyone have any experience in BLF Speed dials that could point me in the right direction?
Cheers,
Phil
02-10-2010 06:19 AM
Just to let anyone know who is interested that I have solved the problem:
The reason why the BLF SD wasn't appearing/working on the phone was that we use Extension mobility. I didn't have the relevant CSS set up for the end user, I only had it set up on the actual device.
Took me a while to figure that one out!
Phil
02-10-2010 07:06 AM
Hey Phil,
Thanks for posting up your results here +5 for
this kind gesture that will undoubtedly help others
down the road.
Cheers!
Rob
09-15-2016 01:39 AM
Old story but always useful info !
Put me out of a lot of waste time today.
Thanks !
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: