sateeshk10 Thu, 02/04/2010 - 19:06

Hi,


Thanks for your reply..I want to restrict the BW on VLAN only...I need configuration/procedure for the same.


Regards

Kumar

Leo Laohoo Thu, 02/04/2010 - 19:22

If you want to limit the bandwidth on the VLAN then the packet shaping should be at the switch.

sateeshk10 Thu, 02/04/2010 - 19:25

Hi,


One of my WLC interface connecting directly to firewal so i can`t do any thing on switch level..I am looking for solution to configure BW restriction on WLC itself.


Regards

kumar

George Stefanick Thu, 02/04/2010 - 18:37

funny how 2 engineers can read a comment and think of it from 2 persepctives ...  although i think he wants to limit bandwidth not disable rates ... I ll give you 5 points if im wrong !

Leo Laohoo Thu, 02/04/2010 - 19:50

How about if you attach your SSID to, say, 802.11b and enable 1mb data rates and disable the rest?

George Stefanick Thu, 02/04/2010 - 20:37

thats thinking out of the box BUT .. now you will have 20 clients

flooding the medium with 1 meg frames and channel utilization will go through the roof!

davidvanzummere... Thu, 04/01/2010 - 07:17

Depending on your setup, if you have a router on the outside of your firewall (handling internet connection).  You can NAT the traffic from your anchor controller to a different outside ip address and then rate limit that ip address on the internet router. 

weterry Fri, 04/02/2010 - 23:13

Why hasn't anyone mentioned per-user bandwidth contracts on the WLC?

It is downstream only, but that is typically what most people are concerned about with guests anyway....

mmangat Wed, 07/10/2013 - 23:50

Hello,


configure a basic class-map/policy-map to police the bandwidth on the gateway interface.


For example:


access-list 10 permit 192.168.1.0


class-map POLICE_GUEST_WLAN

match access-group 10

!

!

Policy-map POLICE

class POLICE_GUEST_WLAN

police 1000000 conform-action transmit exceed-action drop


interface vlanX

service-policy output POLICE


This would police traffic to 1 MB for subnet 192.168.1.0.

Actions

This Discussion