02-05-2010 07:08 AM - edited 07-03-2021 06:28 PM
All,
Is there any way to do a port span or tap of all traffic going to and from a WiSM? You can't seem to monitor the port channel that goes into the controller.
Thanks
Jason
Solved! Go to Solution.
02-05-2010 07:41 AM
Sure, you can set the port-channel interface as the source of the monitor session.
lab1sup720ip1(config)#monitor session 1 source interface ?
FastEthernet FastEthernet IEEE 802.3
GigabitEthernet GigabitEthernet IEEE 802.3z
Port-channel Ethernet Channel of interfaces
02-05-2010 07:41 AM
Sure, you can set the port-channel interface as the source of the monitor session.
lab1sup720ip1(config)#monitor session 1 source interface ?
FastEthernet FastEthernet IEEE 802.3
GigabitEthernet GigabitEthernet IEEE 802.3z
Port-channel Ethernet Channel of interfaces
02-05-2010 08:30 AM
Thanks,
I will meet with security on monday and see if it works.
It did kick out this error:
msndc-ssw1(config)#monitor session 1 source interface po417
% Monitor Session with Service Cards Port-Channel will not be nvgened
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: