Configuring WCCP on router interfaces for WAAS

Unanswered Question
Feb 5th, 2010
User Badges:


I have a question regarding configuring WCCP for WAAS.  If I have a subinterface does the "ip wccp 62 redirect in" command need to be placed on the physical interface only, on the subinterface, or on both interfaces?  Thanks.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Ricardo Prado Rueda Fri, 02/12/2010 - 15:03
User Badges:
  • Cisco Employee,
  • Events Top Contributors,

    Cisco, 2014


   WCCP redirection needs to be configured on the Layer 3 interface (or subinterface) where the ip traffic that needs to be redirected is arriving. Hence, if your main interface does not have an IP address and/or is not receiving ip traffic that needs to be redirected only the subinterface requires this configuration.



tojackson Thu, 11/04/2010 - 09:29
User Badges:

Can the WCCP be added to a VLAN (SVI) interface on a 3560 switch? Or do each of the interfaces need to be L3. Current internet connection is on a flat vlan, PIX and DMZ router are connected to L2 interfaces on the switch, but their addresses are in the same subnet. Do I need to change the DMZ router and PIX interfaces to point-to-point L3 ?


This Discussion