Vocera and 2 Cisco Wireless Services Modules

pingmenow · ‎02-05-2010

We have the following at our facility:

- Vocera system

- 2 Cisco Wireless Services Modules (WiSMs)

Problem:

Badge 1 can only make a successful badge-to-badge call with Badge 2 only if both badges are associated to APs running on WiSM A. If Badge 1 remains associated to an AP running on WiSM A, and Badge 2 associated to an AP running on WiSM B, each badge cannot hear any audio. How can we get the badges to work simultaneously on both WiSMs?

Inventory:

Software Version: 4.2.176.0

Model No.: SVC-WiSM

Configuration changes:

- Enabled IP Multicast Routing

- Enabled PIM

- Disabled IGMP

Any help to resolve this issue will be greatly appreciated.

George Stefanick · ‎02-06-2010

Hello,

A few questions

- Do you have any type of ACL or firewall between the two wisms?

- Are the 2 Wisms in the same cat?

- While on wism a can you ping devices on wism b and the other way around?

- Have you followed Voceras best practices document for a Cisco install?

- Are your contrllers in the same mobility group?

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

Leo Laohoo · ‎02-07-2010

WLC Configuration for AeroScout RFID Tags
http://www.cisco.com/en/US/products/ps6366/products_configuration_example09186a0080870349.shtml

George Stefanick · ‎02-08-2010

Leo, you tipping the bottle again!? LOL RFID tags, HUH!? LOL

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________

Leo Laohoo · ‎02-08-2010

Shhhhh!!! Not too loud. I've got hang-over.