cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
10307
Views
15
Helpful
2
Replies

How to install locale on CUCM 7.1

d-domjahn
Level 1
Level 1

Hi,

I'm just struggeling through the documentation but cannot find any hint how to install additional locales on CUCM 7.1

The documentation talks about a locale installer. For German language support there is a file called "cm-locale-de_DE-7.1.2.4000-1.cop.sgn" - how can it be installed on CUCM?

Is there also a language specific file "cm-locale-combined_network-7.1.2.4000-1.cop.sgn" for Germany or does this file already contain German dial tones etc.?

Thanks a lot in advance!

David

2 Replies 2

Rob Huffman
Hall of Fame
Hall of Fame

Hi David,

This is done via OS Admin>Software Upgrades

Software Upgrades

--------------------------------------------------------------------------------

You can use the Software Upgrades options to perform the following types of installations and upgrades:

Install/Upgrade-Use this option to upgrade the application software, install Cisco Unified Communications Manager Locale Installers and dial plans, and upload and install device packs, phone firmware loads, and other COP files.

TFTP File Management-Use this option to upload various device files for use by the phones to the TFTP server. The TFTP server files that you can upload include custom phone rings, callback tones, and phone backgrounds.

http://www.cisco.com/en/US/docs/voice_ip_comm/cucm/cucos/6_0_1/cucos/iptpch7.html


When using Cisco Unified CallManager Release 5.0 or later


For Cisco Unified CallManager 5.0, you must do all software installations and upgrades by using the Software Upgrades menu options. The system can upload and process only software that Cisco Systems approved. You cannot install or use third-party or Windows-based software applications that you may have been using with a previous version of Cisco Unified CallManager with Cisco Unified CallManager 5.0.

Using your web browser, login to the Cisco IPT Platform Administration web page

Under the Software Upgrades menu, select Install/Upgrade.

Fill in the appropriate values in the Software Location section for the file you downloaded above, and click Next.

In the Available Software drop-down box, select the file you downloaded above, and click Next.

After validating the MD5 has the correct value, click Next.

In the Warning box, verify you have selected the correct firmware, then click Install.

Check that you received a Success message.

Hope this helps!
Rob

PS: When you go to download the files from CCO there should be a ReadMe that describes

the contents of each.

Thanks a lot - I'll give it a try!

Regards,
David

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: