cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
1636
Views
0
Helpful
3
Replies

DTMF Using SIP for Skype Issue?

brian.russell31
Level 3
Level 3

Hi Guys,

Just wondering if you have resolved the DTMF issue using the SIP for skype yet as I still have the issue?

Thanks

Brian

3 Replies 3

Maulik Shah
Level 5
Level 5

Hi Brian

  We have not seen any DTMF issues with Skype for SIP recently - this was reported earlier with resolution as below - can you check these and see:

https://www.myciscocommunity.com/docs/DOC-10787#comment-3084

https://www.myciscocommunity.com/message/29180#29180

The one outstnading DTMF issue we are aware off on the UC500 SIP trunks is below but I think this is not an issue with Skype as they do not use Sonus GWs:

http://tools.cisco.com/Support/BugToolKit/search/getBugDetails.do?method=fetchBugDetails&bugId=CSCtd68173

This is seen in 8.0.0 SW pack and a fix SW Pack is scheduled to come out end of Feb / early Mar. If you need a private build for 8.0.0, PM me your cisco.com user ID and current platform / version.

Hi Guys,

Spoke with Skype support today and they have told me this:

Mihkel - Skype Support says

Good. Check that your SIP-enabled PBX is configured to use RFC 2833 (sometimes described as ‘out of band’) DTMF with Skype for SIP Beta.
17:07:07 Mihkel - Skype Support says
Also, Skype recommends that your SIP-enabled PBX uses RTP Payload Type 101 for the SIP message’s telephone-event.
Can anyone help me with this?
Thanks
Brian

The answer is UC500 does use RFC2833 for DTMF with payload type 101 - if you have a wireshark capture for a failed call with DTMF then I can exactly point out where this shows up in there so you can send to Skype.

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: