cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
409
Views
0
Helpful
2
Replies

DSP and Voice Port configuration on 1760-V

johnnylingo
Level 5
Level 5

Hmmm...So I'm trying to migrate from a 2600 to 1760.  DSPs are installed, as is a VIC-2FXS card.  But I'm having no luck getting the DSPs or voice ports to show up. 

Any ideas?

# sh ver

Cisco IOS Software, C1700 Software (C1700-SPSERVICESK9-M), Version 12.4(15)T10, RELEASE SOFTWARE (fc3)


# sh inv

NAME: "WIC/VIC 2", DESCR: "Two port FXS voice interface daughtercard"
PID: VIC-2FXS=         , VID: 1.1, SN: 20558160  

NAME: "DSP Module Slot 0", DESCR: "Packet Voice DSP Module Slot 0"
PID: Packet Voice DSP Module Slot 0, VID:    , SN:           

NAME: "DSP Module Slot 1", DESCR: "Packet Voice DSP Module Slot 1"
PID: Packet Voice DSP Module Slot 1, VID:    , SN:           

# show dspfarm all
DSPFARM Configuration Information:
Admin State: DOWN, Oper Status: DOWN - Cause code: ADMIN_STATE_DOWN
Transcoding Sessions: 0(Avail: 0), Conferencing Sessions: 0 (Avail: 0)
Trans sessions for mixed-mode conf: 0 (Avail: 0), RTP Timeout: 600
Connection check interval 600 Codec G729 VAD: DISABLED

Total number of active session(s) 0, and connection(s) 0

1 Accepted Solution

Accepted Solutions

paolo bevilacqua
Hall of Fame
Hall of Fame

Which PVDM you used? Need to be PVDM256-xx. Try "show diag".

View solution in original post

2 Replies 2

paolo bevilacqua
Hall of Fame
Hall of Fame

Which PVDM you used? Need to be PVDM256-xx. Try "show diag".

Ahh...well the answer to that apparent is "none".  My understanding was the 1760-V came bundled with a PVDM, but apparently not.  Both slots are empty!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: