- Bronze, 100 points or more
Hello network experts,
I am new on this forum and i would like to ask if somebody have experience with ISP network architecture. I want to simulate real network situation as you can see in screenshot but I have some problems with routing or NAT configuration.
Now the network shown in screenchot works fine and I can do ping from workstation 192.168.8.165 to external network 184.108.40.206. Also i can ping from 192.168.1.1 to 220.127.116.11, so basically network works fine but there is one problem with NAT or routing (probably).
I have decided to assign some specific external IP (NAT) for inside host 192.168.8.166. This IP is from another range than between PIX(FW0) and ISP router(R0). So ISP assigned me 18.104.22.168/27 network range for my servers to be reachable (NATed) outside internet (in this case R0).
On PIX(FW0) I created new static nat 192.168.8.165 --> 22.214.171.124 and now I want to make this IP available from another network (like from internet) for example from network 126.96.36.199. But when I try to ping from 188.8.131.52 result is timeout.
How should I configure R0 to be able to route NAT pool (184.108.40.206/27) to another networks ??? This IP addresses are real and it is range what I got from ISP provider and I would like to know how it is configured on ISP side.Could someone help with it or tell me how does it works ?
My network is terminated by PIX and there is no other router on my side. I am connected to ISP side with normal ethernet cable (no serial cable or other type of connection, no frame relay) Which routing protocol should I use ?
I hope that description is clear.Thank you very much for help :-)