Authenticating IOS WGB to WLC via EAP-FAST

lmslattery · ‎02-09-2010

Hi All,

I note that in the WLC v6.0 config guide support for EAP-FAST is listed under the workgroup bridge configuration section.

Has anyone been successfull in getting this working ? or have a config example ?

I've had limited success on setting up a WGB wto Auth via WPA2-PSK , but no luck with EAP-FAST.

Documentation for this stuff seems to be a bit light on.

WLCs are 4402's running v6.0 with ACS 4.2 as my auth server.

Thanks,

Leon

peterkuric · ‎09-23-2010

Use this in your WGB config:

eap profile eapfast
method fast

!

dot11 ssid
   authentication open eap eap_methods
   authentication network-eap eap_methods
   authentication key-management wpa
   authentication client username password
   dot1x eap profile eapfast

That should do it.

I've had success using a few different 12.4 IOS versions but not on 12.3(7)JA3

Also works with Dynamic VLAN Assignment from ACS

Vinay Sharma · ‎09-25-2011

Hello Leon,

Please mark the Question as Answered, if the provided information by Peter is correct and it helped. By doing that others can take benefit as well.

Thanks,

Vinay Sharma

Community Manager – Wireless

Thanks & Regards