CCME Internal Dialing Question

Unanswered Question
Feb 9th, 2010
User Badges:

First off, thanks in advance for helping out on this.  I know it should be easy but for some reason I cant figure it out.

I have set up a test CCME and everything is working just fine.  I have 2 phones and they are registered and all is well.  What I am trying to do is not make them call each other.  I would like to basically partition them so they can not dial each other.  I know this is easy in CallManager but I am having a difficult time in CCME.  My router is an old 1751-V running CCME 4.0(3).  I have tired ACL's and that only kills the RTP stream and I have also tried COR lists. Anybody have any ideas on how to make Phone 1 not call Phone 2?

I will post my config if needed.



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
paolo bevilacqua Wed, 02/10/2010 - 02:04
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    Founding Member

There is more than one way.

Search "understand COR".


This Discussion

Related Content