02-10-2010 01:43 AM - edited 03-11-2019 10:07 AM
I have ASA5510 and short configration as below
interface Ethernet0/1
speed 100
duplex full
nameif inside
security-level 100
ip address 192.168.1.1 255.255.255.0
!
interface Ethernet0/2
speed 100
duplex full
nameif inside2
security-level 100
ip address 192.168.10.1 255.255.255.0
same-security-traffic permit inter-interface
--------------------------------------------------------------------------
I wanto to connect from 192.168.1.10 which is under Ethernet0/1 to 192.168.10.10 which is under Ethernet0/2.
But I could not.
Do I need to add any configration?
Solved! Go to Solution.
02-10-2010 05:49 AM
So you have to declare nat exemptions for both networks on both interface
02-10-2010 05:11 AM
What can you in the log when you try to route traffic from one interface to the other?
02-10-2010 05:29 AM
This is ASA configration.
Should I use subinterface?
02-10-2010 05:33 AM
You are not obliged to use subif, try to issue the "no nat-control" command
02-10-2010 05:41 AM
But I am using nat function because there is a mail server under inside interface.
02-10-2010 05:49 AM
So you have to declare nat exemptions for both networks on both interface
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: