Mixing 1240 and 1250 access-point Lightweight

Unanswered Question
Feb 10th, 2010
User Badges:

HI all,

is it possibile to have a system of WLCs controlling both 1242 and 1252 installed in different areas of a factory and (1250 at offices and 1240 at production site) managing the same WLANs?



  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Stephen Rodriguez Wed, 02/10/2010 - 05:57
User Badges:
  • Purple, 4500 points or more

This works with out a problem.  so long as the code supports the AP, you can mix and match the AP' to your networks contect.

Leo Laohoo Wed, 02/10/2010 - 17:15
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

The latest 4.X and 6.X supports 1240 and 1250.  You can mix both.  You can verify by reading the Release Notes and it will tell you what AP's are supported by the firmware.


This Discussion