Hi all,
I am trying to enable traffic shaping over a Multilink consisting of 3 T1 serial interfaces. I have to configure shaping 90% of total bandwidth (4.5 Mbps). However, it gives me error message that shaping is restricted to individual serial link bandwidth.
Router(config-if)#service-policy output SHAPE-4.5M
%4050000 bps is greater than interface Serial1/1.1/1:0 rate (1536000 bps),
class 'class-default'
%4050000 bps is greater than interface Serial1/1.1/2:0 rate (1536000 bps),
class 'class-default'
%4050000 bps is greater than interface Serial1/1.1/3:0 rate (1536000 bps),
class 'class-default'
Is there an option to configure it? This is an OSM module on Cisco 7600 router.
Thanks,
Faad