Cisco Rouer 1841 problem on F0/0 and F0/1 no power

Answered Question
Feb 10th, 2010
User Badges:

Dear All,


I want to ask you that i have cisco Router 1841 but on port F0/0 and port F0/1 not have power when i plug cable to this port.

this is message that i got :


Router(config)#do sh ip int br
Interface                  IP-Address      OK? Method Status                Protocol
FastEthernet0/0            192.168.1.1     YES NVRAM  up                    down   
FastEthernet0/1            192.168.2.1     YES NVRAM  up                    up     
Router(config)#


*Feb 11 04:23:48.955: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0  State changed to: Initialized
*Feb 11 04:23:48.959: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0  State changed to: Enabled Phy reset failed


Router(config-if)#Phy reset failed


what is going on ?


Best Regards,

Norung

Correct Answer by Leo Laohoo about 7 years 3 months ago

Hi Norung,


What do you mean "power"?  Both ports are not PoE.

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Leo Laohoo Wed, 02/10/2010 - 20:38
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Hi Norung,


What do you mean "power"?  Both ports are not PoE.

rechard_hk Wed, 02/10/2010 - 20:49
User Badges:

Dear leolaohoo,


I mean that when we plug cable to Router then we see light on on port ( link,100 and FDX) but my problem is when i connect it i dont see the light.


Sorry i wrong to cleck correct answer.....

Leo Laohoo Wed, 02/10/2010 - 20:56
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

FastEthernet0/1 is OK but FastEthernet0/0 isn't.  Can you post the config?

Actions

This Discussion