02-10-2010 08:35 PM - edited 03-04-2019 07:28 AM
Dear All,
I want to ask you that i have cisco Router 1841 but on port F0/0 and port F0/1 not have power when i plug cable to this port.
this is message that i got :
Router(config)#do sh ip int br
Interface IP-Address OK? Method Status Protocol
FastEthernet0/0 192.168.1.1 YES NVRAM up down
FastEthernet0/1 192.168.2.1 YES NVRAM up up
Router(config)#
*Feb 11 04:23:48.955: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0 State changed to: Initialized
*Feb 11 04:23:48.959: %VPN_HW-6-INFO_LOC: Crypto engine: onboard 0 State changed to: Enabled Phy reset failed
Router(config-if)#Phy reset failed
what is going on ?
Best Regards,
Norung
Solved! Go to Solution.
02-10-2010 08:38 PM
02-10-2010 08:38 PM
Hi Norung,
What do you mean "power"? Both ports are not PoE.
02-10-2010 08:49 PM
Dear leolaohoo,
I mean that when we plug cable to Router then we see light on on port ( link,100 and FDX) but my problem is when i connect it i dont see the light.
Sorry i wrong to cleck correct answer.....
02-10-2010 08:56 PM
FastEthernet0/1 is OK but FastEthernet0/0 isn't. Can you post the config?
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: