Access Point switch configuration

Unanswered Question
Feb 10th, 2010

We have 4402 wireless Controller with 1132 AP, in switch we need to configure access vlan or trunk for Acees point, when I try acess point as trunk vlan, it is not get registered with controller. Please light me about switch configuration on access point with controller.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Leo Laohoo Wed, 02/10/2010 - 22:07

Switch to AP = access port (same vlan as your Management IP address of the switch)
Switch to WLC = Trunk

BALAMURUGAN SINGARAM Wed, 02/10/2010 - 22:59

thanks for the reply, configure access point with access vlan, it is possible to advertise different SSID [ different vlan ] with access point, please reply me.

Also in controller 4402, under WLAN we need to configure different Vlan, when we add NEW WLAN we get only SSID GUI page, not able to get VLAN ID on that page, please help me what I am missing on this.


This Discussion