cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
2049
Views
0
Helpful
3
Replies

VG224 SCCP and Modems..

jmachiggins
Level 1
Level 1

I am cureently trying to get modems to work over an SCCP VG224 with CallManager 7.  At present the modems can recieve but cannot send.  The PSTN gateway they are using is MGCP and everything is configured for Modem Pass through end to end.  Has anyone seen anything like this before?

Thanks,

Justin

3 Replies 3

paolo bevilacqua
Hall of Fame
Hall of Fame

Modem passthrough doesn't seem a good idea.

Should use modem relay and H.323.

Or place FXS cards in router, end of any trouble,.

I found that VG224's are great for Fax's, but not for modems. I use ATA

186/188's for modems as they worked without any issues.

Phil

Jason Hendrix
Level 1
Level 1

Maybe a little on the late side but... have a VG2951, VG224 CUCM 7.1.3 H323. Gas company calling inbound on DID line through VG224 and they could not connect did the changes to the port below and Gas compnay can now connect to modem, all the best.

conf t

voice-port 2/xx

shut

input gain 6 <-- normally at 0

output attenuation 10 <-- normally at 0

idle-voltage high

no shut

end

write memory

show run and look for port

!

voice-port 2/11

input gain 6

output attenuation 10

timeouts initial 60 <-- was already set to this

timeouts interdigit 60 <-- was already set to this

timeouts ringing infinity <-- was already set to this

description Gas Modem Line x143 <-- add a description for me

!

Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: