Using NAT with DHCP on Wan side

Answered Question
Feb 11th, 2010
User Badges:

Hey guys, I'm currently enrolled in the cisco networking academy through school, and I will be soon purchasing a Cisco 2600 series router to practice with at home.


I was doing some configuring on packet tracer, and was wondering if it is possible to setup NAT to provide internet access for multiple PCs on a cable internet connection (DHCP).


ip nat pool pool_name start_ip end_ip netmask a.b.c.d


From what I understand on this command is that you can only translate LAN addresses to a static WAN address.


Any help would be greatly appreciated.

Correct Answer by Giuseppe Larosa about 7 years 3 months ago

Hello Steven,


you can use something like


ip nat source inside list 11 interface wan_interface_name overload


this is the typical setup the key is to use the interface name as a reference


Hope to help

Giuseppe

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Loading.
Correct Answer
Giuseppe Larosa Thu, 02/11/2010 - 23:05
User Badges:
  • Super Silver, 17500 points or more
  • Hall of Fame,

    Founding Member

Hello Steven,


you can use something like


ip nat source inside list 11 interface wan_interface_name overload


this is the typical setup the key is to use the interface name as a reference


Hope to help

Giuseppe

Steven Tolzmann Thu, 02/11/2010 - 23:10
User Badges:

Yeah I actually JUST figured that out, while I was researching it a bit more.


Ended up using


int fa0/1

ip nat inside

int fa0/0

ip nat outside

ip nat inside source list 7 interface fa0/0 overload

access-list 7 permit 10.10.0.1 0.0.0.254


my addresses are now translating in packet tracer ^_^


Thanks.

skhawari83 Wed, 03/01/2017 - 16:24
User Badges:

Hello Steven,


Did you manage to get this resolved. I want to set something similar on 2911 router.

Actions

This Discussion