wireless Lan controller not access by GUI interface

Unanswered Question
Feb 12th, 2010

Hi All,

         i have one new cisco WLC 2106.i am not able access it by GUI interface.please help me how can i access it.It is true i am totally new for cisco wlc.

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Arup Dutta Fri, 02/12/2010 - 01:00

Hi Leo,

thank you for your quick reply but i had done each and every thing and

after that i am not able to access it.already i had configure like that

which is mention below.

(Cisco Controller) >show interface detailed management

Interface Name................................... management

MAC Address...................................... 00:1b:d5:cf:c5:40

IP Address....................................... 10.0.0.254

IP Netmask....................................... 255.0.0.0

IP Gateway....................................... 10.0.0.1

External NAT IP State............................ Disabled

External NAT IP Address.......................... 0.0.0.0

VLAN............................................. untagged

Quarantine-vlan.................................. 0

Physical Port.................................... 2

Primary DHCP Server.............................. 10.0.0.100

Secondary DHCP Server............................ Unconfigured

DHCP Option 82................................... Disabled

ACL.............................................. Unconfigured

AP Manager....................................... No

Guest Interface.................................. No

(Cisco Controller) >

please help me.

On Fri, Feb 12, 2010 at 2:24 PM, leolaohoo <

Leo Laohoo Fri, 02/12/2010 - 01:05

Can you ping the Management IP Address?
Is HTTP enabled (by default HTTP is disabled but HTTPS is enabled)?
Have you tried HTTPS?

Arup Dutta Fri, 02/12/2010 - 01:09

Hi Leo,

i am able to ping this management ip 10.0.0.254 by console but not

my system and i tried both http:
ip and https:

System(Laptop) ip is 10.0.0.222 gateway 10.0.0.254 and also tried none.

On Fri, Feb 12, 2010 at 2:35 PM, leolaohoo <

Leo Laohoo Fri, 02/12/2010 - 01:16

sudhutorjonno wrote:

VLAN............................................. untagged

Right, well I believe the link between the WLC and the switch should be a dot1q Trunk.

Arup Dutta Fri, 02/12/2010 - 01:24

hi,

my setup just like that,

WLC IS CONNECT MY SYSTEM BY A rj45 CABLE.

please tell network scenario so that i can access it by GUI interface.

On Fri, Feb 12, 2010 at 2:46 PM, leolaohoo <

Leo Laohoo Fri, 02/12/2010 - 01:29

Which port of the 2106 is your laptop connected to?
What is the subnet mask of your laptop?
Disable firewall on the client.

Arup Dutta Fri, 02/12/2010 - 01:31

hi,

port 2 is connected on my system.

subnet is 255.0.0.0

system firewall is disable

waiting for your response

On Fri, Feb 12, 2010 at 2:59 PM, leolaohoo <

Actions

This Discussion