Compatibility with 4400 and 5500

Unanswered Question
Feb 12th, 2010
User Badges:


I have a doubt, there is an existing setup of 4400 series controller. I would like to add more access points , which the current controller cannot accommodate, also client requires redundancy in the solution. I was wondering, if it is possible to add 5500 controller and configure one to one redundancy b/w 4400 controller and 5500 series.


Siddarth .

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Marcus Johansson Fri, 02/12/2010 - 05:59
User Badges:

yes it should work just fine, just make sure you have the same version of software on both, i.e version 6.0.x!

George Stefanick Fri, 02/12/2010 - 15:26
User Badges:
  • Purple, 4500 points or more
  • Community Spotlight Award,

    Best Publication, October 2015

I see no reason why you couldn't. But make sure you share the same code and update the

mobility group.


This Discussion