02-12-2010 02:46 AM - edited 03-11-2019 10:08 AM
Hello everyone,
Here's my setup:
PIX-515E Release 6.3
3 physical interface: IN, OUT, DMZ
I have a problem about the flow through between a PC on the inside and a pc on the DMZ.
The flow between the 2 machines is about 60kB in one direction and about 500kB in another.
I tested with different cables RJ45, switch and PC but the result is the same.
When I put the 2 PCs on the inside I have a throughput of about 10MB fairly reasonable.
For me it just my PIX, you have already encountered this problem? Is there a parameter to be added to allow better flow between certain interface?
Thank you in advance for your answers.
Rémi
Solved! Go to Solution.
02-12-2010 07:16 AM
Remi,
Collect the output again and see if the counters increment.
If so may be try to change the setting to auto auto on both ends (switch and firewall) and see if the errors will go away.
sh int e0/0
do it for each interface and findout which interface is seeing errors.
-KS
02-12-2010 03:05 AM
have you tested throughput between two
devices on the DMZ?
02-12-2010 04:34 AM
Thanks for your answer,
Yes I have tested throughput between two devices on the DMZ and the result is also correct (near 10MB)
If you have another idea..
Rémi
02-12-2010 06:10 AM
sh int | i errors
do any of them show errors?
-KS
02-12-2010 06:39 AM
Have you checked speed and duplex settings are fixed 100mb full duplex on clients switch ports and pix interface ports.
Are there any errors on pix interface ports?
Regards,
Paul McGowan
Capita IT Services
Sent From Blackberry
02-12-2010 07:10 AM
Thanks for your answer,
Yes, all interfaces are fixed 100mb full duplex and switch too.
But:
sh int | i errors
0 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 output errors, 0 collisions, 0 interface resets
2232467 input errors, 1616434 CRC, 0 frame, 0 overrun, 1616434 ignored, 0 abort
0 output errors, 0 collisions, 0 interface resets
260 input errors, 0 CRC, 0 frame, 0 overrun, 0 ignored, 0 abort
0 output errors, 0 collisions, 0 interface resets
02-12-2010 07:16 AM
Remi,
Collect the output again and see if the counters increment.
If so may be try to change the setting to auto auto on both ends (switch and firewall) and see if the errors will go away.
sh int e0/0
do it for each interface and findout which interface is seeing errors.
-KS
02-12-2010 07:33 AM
Yes the counters increment in mode 100full
But in settings mode "auto" on the inside and DMZ now it's OK!!
Many thanks, throughput are great now !!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: