threat-detection configuration on ASA5520 Version 8.2(1)

Unanswered Question
Feb 12th, 2010

Hi,

I want to get statistics about how often I am under attacks and the nature of the attacks.

I read many documents about how to activate threat-detection in ASA v8. For this, I need to type the following command: threat-detection basic-threat. Unfortunately I don't have this command and I don't have "show threat-detection statistics port/protocols" either.

The only available commands are: "threat-detection statistics tcp-intercept ...".

I am in a ASA5520 in version 8.2(1) in configure terminal.

Do you have any Idea why these commands are not available?

Many thanks!

I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
atosorigin Fri, 02/12/2010 - 06:58

Thanks for your reply. Unfortunately I already saw this documentation.

As I said these commands should be available but for any reason, I don't know why they don't appear.

Here you can see that I have only the threat-detection statistics command available:

SPGLO0001FW/BACK(config)# threat-detection ?


configure mode commands/options:
  statistics  Keyword to configure statistics of threat detection

What could be the reason? Is a license needed?

If it helps, below the show version result:


SPGLO0001FW/BACK# sh ver

Cisco Adaptive Security Appliance Software Version 8.2(1)
Detected an old ASDM version.
You will need to upgrade it before using ASDM.

Compiled on Tue 05-May-09 22:45 by builders

SPGLO0001FW up 28 days 1 hour
failover cluster up 28 days 1 hour

Hardware:   ASA5520

Licensed features for this user context:
Failover                     : Active/Active
VPN-DES                      : Enabled
VPN-3DES-AES                 : Enabled
GTP/GPRS                     : Disabled
Botnet Traffic Filter        : Disabled

Actions

This Discussion