Solved: Filter to show APs with clients.

Smason · ‎02-12-2010

Hi,

How do I create a filter by AP on my 4400 series WLC to show all the clients associated to those APs? Thanks in advance.

braggb001 · ‎02-12-2010

Samantha,

This may be different depending on the version of code you are running, but this would be how you do it when running ver. 4.2.176.0

Web into the Controller
With the "Monitor" tab selected (home screen) click the "Clients" link on the left.
Near the top click the "Change Filter" link
Check the box next to "AP Name"
Enter the name of the Access-Point you would like to filter by

That should be it. Hope this helps.

View solution in original post

braggb001 · ‎02-12-2010

Samantha,

This may be different depending on the version of code you are running, but this would be how you do it when running ver. 4.2.176.0

Web into the Controller
With the "Monitor" tab selected (home screen) click the "Clients" link on the left.
Near the top click the "Change Filter" link
Check the box next to "AP Name"
Enter the name of the Access-Point you would like to filter by

That should be it. Hope this helps.

Smason · ‎02-12-2010

Thank you it worked.

George Stefanick · ‎02-12-2010

Great post Bragg 5+ !

If you have WCS you can pull this reporting as well!

"Satisfaction does not come from knowing the solution, it comes from knowing why." - Rosalind Franklin
___________________________________________________________