02-13-2010 07:02 PM - edited 07-03-2021 06:30 PM
Hello,
I am trying to upgrade a stand alone 1121 AP's (bridging, not controlled by a WLC) security config from WEP to WPA2.
I found this guide for the 1310...
http://www.cisco.com/en/US/tech/tk722/tk809/technologies_configuration_example09186a008054339e.shtml
But this 1121 menus do not match and I can not find one after a good hour of searching. Does anyone know where I can find a config guide for it?
Thank you!
02-13-2010 07:24 PM
What IOS version do you have?
Have you tried using the CLI?
02-14-2010 05:02 AM
12.2(13)JA4
I have cli access as well if needed but would still need a config guide as I am not familiar with these devices.
Thank you.
02-14-2010 01:21 PM
I recommend you try configuring using CLI. Unfortunately the business units that are responsible for updating outdated documents have been doing a "bang-up" job. If you are able to successfully configure WPA2, then I recommend you rate that page appropriately so they (the Cisco business unit) can update the documents.
02-19-2010 06:26 PM
I see that I can use Migration mode to have both WEP and WPA on the same AP.
I further see that I can use mixed mode so that I have both WPA and WPA2 at the same time.
Does anyone know if I can use both tools to have all 3 encryption types at the same time?
Thanks!
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide