HUM thresholds: is it possible to watch a line in the graphs?

Unanswered Question
Feb 15th, 2010


I´m configuring HUM thresholds and I would like to watch them as a line in the graphs. By now, I haven't seen what I want. My question is: is it possible to do this?


I have this problem too.
0 votes
  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 5 (1 ratings)
Joe Clarke Mon, 02/15/2010 - 18:02

I'm not sure I follow.  If you're using LMS 3.2, you can use the LiveGraphIt portlet to graph an SNMP object value in real time.  You could then see if a threshold is violated by observing if the value crosses a given line.

cmartinvalle Mon, 02/15/2010 - 23:13

Yes, I want to see the SNMP object in real time and a line in the same graph that would be the threshold configured for that poller. I've been creating Histo GraphIts and reports and I haven't been able to watch these threshold lines, only the SNMP object values. Do I have to configure something special to see it?

Joe Clarke Mon, 02/15/2010 - 23:53

You cannot graph the threshold, but you can graph the MIB object value in real time using the LiveGraphIt portlet.  You can also view threshold violations in the Threshold Information portlet.


This Discussion