Reza Sharifi Mon, 02/15/2010 - 12:08
User Badges:
  • Super Bronze, 10000 points or more
  • Cisco Designated VIP,

    2017 LAN

Hi Tom,


If you do a Write Erase, you will loose all your config on the box including your session. Then you have to send some one with  console cable to reconfigure it.


HTH

Reza

Federico Coto F... Mon, 02/15/2010 - 12:09
User Badges:
  • Green, 3000 points or more

Hi,


If you did wr erase on the remote router, that erased the startup configuration. It means there's no IP address on the router, therefore you cannot access it remotely.


You cannot PING or telnet/SSH into the router anymore correct?


If the router was rebooted, there's nothing to be done but copy a working configuration on the router again, or console in.


If the router has not been reloaded, you can copy the working running-config to the startup-config again.


Federico.

tomfree_leo Mon, 02/15/2010 - 12:24
User Badges:

thankz guyz for the reply.

I got to get a support on site ; no wayout

Actions

This Discussion