catalyst 2950 and 3750 console not responding after successful boot

Unanswered Question
Feb 15th, 2010
User Badges:

i just removed two switches from my ccie R&S lab but now i has a very strange problem switches is working fine but i can not access from console after boot .

  • 1
  • 2
  • 3
  • 4
  • 5
Overall Rating: 0 (0 ratings)
Loading.
Leo Laohoo Mon, 02/15/2010 - 20:04
User Badges:
  • Super Gold, 25000 points or more
  • Hall of Fame,

    The Hall of Fame designation is a lifetime achievement award based on significant overall achievements in the community. 

  • Cisco Designated VIP,

    2017 LAN, Wireless

Someone must've adjusted the baud settings.

khalid_lali Tue, 02/16/2010 - 09:34
User Badges:

Baud rate is 9600 its ok even i can see the console logs but cant work on it.

Kevin Dorrell Tue, 02/16/2010 - 20:11
User Badges:
  • Green, 3000 points or more

Do you have any other devices you could use to check your terminal emulator is working?  I had an issue with hyperterminal once, that it would not transmit following a reboot of the device it was managing.  But in my case, re-booting the PC (with a proper power cycle) cleared the problem, so it couzld have been something to do with flow control.


Kevin Dorrell

Luxembourg

Hassan Khawaja Thu, 06/19/2014 - 04:48
User Badges:

Hi Khalid,

       I am having the same problem with 2960 Catalyst Switch. Switch boots and the booting process shows up on console, but after the boot-up, console Hangs. Did you find the solution for your problem? How did you solve it ?

Thanks

Hassan

Actions

This Discussion