Buy or Renew
Buy or Renew
Cisco + Splunk: It’s a new day for your data. Learn more.
 
cancel
Turn on suggestions
Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Showing results for 
Search instead for 
Did you mean: 
cancel
Start a conversation
1230
Views
0
Helpful
4
Replies

catalyst 2950 and 3750 console not responding after successful boot

khalid_lali
Level 1
Level 1

‎02-15-2010 07:38 PM - edited ‎03-06-2019 09:43 AM

i just removed two switches from my ccie R&S lab but now i has a very strange problem switches is working fine but i can not access from console after boot .

Labels:
0 Helpful
4 Replies 4

Leo Laohoo
Hall of Fame
Hall of Fame

‎02-15-2010 08:04 PM

Someone must've adjusted the baud settings.

0 Helpful

khalid_lali
Level 1
Level 1
In response to Leo Laohoo

‎02-16-2010 09:34 AM

Baud rate is 9600 its ok even i can see the console logs but cant work on it.

0 Helpful

Kevin Dorrell
Level 10
Level 10
In response to khalid_lali

‎02-16-2010 08:11 PM

Do you have any other devices you could use to check your terminal emulator is working?  I had an issue with hyperterminal once, that it would not transmit following a reboot of the device it was managing.  But in my case, re-booting the PC (with a proper power cycle) cleared the problem, so it couzld have been something to do with flow control.

Kevin Dorrell

Luxembourg

0 Helpful

Hassan Khawaja
Level 1
Level 1

‎06-19-2014 04:48 AM

Hi Khalid,

       I am having the same problem with 2960 Catalyst Switch. Switch boots and the booting process shows up on console, but after the boot-up, console Hangs. Did you find the solution for your problem? How did you solve it ?

Thanks

Hassan

0 Helpful
Getting Started

Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community:

Customers Also Viewed These Support Documents
Review Cisco Networking products for a $25 gift card